How to flash Samsung Galaxy J2 via Odin 3.10.7, This method can be used to overcome various damage to the OS (Operation System) Samsung Galaxy J2, Damage on Samsung Galaxy J2 system can certainly cause interference in Samsung Galaxy J2, One of them can cause Samsung Galaxy J2 Botloop.
Bootloop Samsung Galaxy J2 is a situation where when we turn on the Samsung Galaxy J2, Samsung Galaxy J2 can not access the main menu or the initial screen Samsung Galaxy J2, Samsung Galaxy J2 screen usually appears only Samsung Galaxy J2 logo, To overcome botloop Samsung Galaxy J2 you can To upgrade OS Samsung Galaxy J2 with flash Samsung Galaxy J2 via Odin 3.10.7 which you can follow below.
To be able to flashing Samsung Galaxy J2 via Odin, you must prepare the required materials such as Samsung Galaxy J2 firmware, Samsung Galaxy J2 and Odin drivers that we will use Odin v3.10.7. Please download some of the materials needed below.
Materials needed
This is how to flash Samsung Galaxy J2 via v3.10.7 that we can share in Androwid.tk this, May flash way Samsung Galaxy J2 can be useful for you who are still looking for flash Samsung Galaxy J2 and see also here How to Hard reset and Factory reset Samsung Galaxy J2
To be able to flashing Samsung Galaxy J2 via Odin, you must prepare the required materials such as Samsung Galaxy J2 firmware, Samsung Galaxy J2 and Odin drivers that we will use Odin v3.10.7. Please download some of the materials needed below.
Materials needed
Tutorial how to flash Samsung Galaxy J2 SM-J200
- Extract all the materials you have downloaded above on your computer / Laptop.
- Install Samsung Driver on computer (Install driver is useful so Samsung Galaxy J2 can be detected by Odin on computer)
- Turn off Samsung Galaxy J2
- Go to Download mode Samsung Galaxy J2 by press and hold down Volume Down + Home + Power simultaneously until the Warning !! appears, then press the Volume Up button once to proceed to Download mode Samsung Galaxy J2.
- Next connect the Samsung Galaxy J2 to the computer using a USB cable (Use a USB kebel that has good quality to avoid the failure of Samsung Galaxy J2 flash process)
- Run Odin3 v3.10.7
- Make sure Samsung Galaxy Samsung Galaxy J2 detected Odin3 v3.10.7, To find out Samsung Galaxy J2 already detected Odin please see the port ID: COM in the picture below
- Enter the Samsung Galaxy J2 firmware on the AP tab in Odin3 v3.10.7
- If everything is set up correctly, Next Click START to start the flash process firmware Samsung Galaxy J2 via Odin3 v3.10.7
- Wait for the Samsung Galaxy J2 flash process via odin to finish.
- If Samsung Galaxy J2 flash process via Odin3 v3.10.7 is finished you will see PASS writing as shown below.
- Flash Samsung Galaxy J2 via Odin finished and succeeded.
This is how to flash Samsung Galaxy J2 via v3.10.7 that we can share in Androwid.tk this, May flash way Samsung Galaxy J2 can be useful for you who are still looking for flash Samsung Galaxy J2 and see also here How to Hard reset and Factory reset Samsung Galaxy J2